GoalReview the rate of a reaction, how to measure it, and how surface area, temperature and concentration change it, with new problems.
New words
average rate · the amount of product made (or reactant used) divided by the time takensurface area · the total area of the outside of an object; cutting a solid into pieces increases itconcentration · the amount of solute in a given volume of solution, for example in g/dm³anomalous result · a reading that does not fit the pattern of the others
Explanation
The rate of a reaction is the amount of product made, or reactant used, in a given time, for example in cm³/s or g/s. On a graph of product against time, the steepest part is where the reaction is fastest, and the line levels off when a reactant is used up. The final amount depends on the amount of the limiting reactant and not on how fast the reaction goes. A reaction happens when particles collide with enough energy. A higher temperature makes particles move faster, so collisions are more frequent and more energetic. A powder has a greater surface area than a lump, so more particles are exposed to collisions. A higher concentration packs more particles into the same volume, so there are more collisions per second. The rate falls as the reactants are used up. Concentration in g/dm³ is mass in g ÷ volume in dm³, with 1 dm³ = 1000 cm³. In a fair test, change one variable, keep the others the same, repeat, and leave out an anomalous result when finding the mean.
Change
What happens to the particles
Rate
Final amount (limiting reactant unchanged)
higher temperature
faster, more energetic collisions
faster
same
more surface area
more particles exposed
faster
same
higher concentration
more particles in the same volume
faster
same
more of the limiting reactant
—
about the same at the start
larger
Worked examples
Time (s)
Large chips: gas (cm³)
Small chips: gas (cm³)
0
0
0
30
16
24
60
26
34
90
32
36
120
35
36
150
36
36
Large chips and small chips of marble (calcium carbonate) of the same mass, each with the same acid in excess, in a teacher’s demonstration with a gas syringe. In the first 30 s the average rate is 16 ÷ 30 = 0.53 cm³/s for the large chips and 24 ÷ 30 = 0.80 cm³/s for the small chips. Between 30 s and 60 s the large chips make 26 − 16 = 10 cm³, which is 10 ÷ 30 = 0.33 cm³/s: the rate has fallen. Both runs end at 36 cm³, because the mass of marble is the same.
Situation
Change
Rate
an antacid tablet in the mouth
chew it instead of swallowing it whole
faster (more surface area)
limescale in a kettle with a descaler
use a stronger solution of the descaler
faster (higher concentration)
a stain in washing powder solution
use warm water instead of cold
faster (more energetic collisions)
the same limescale
dilute the descaler with water
slower (lower concentration)
Which change speeds up which process? A table to predict the rate.
Part of the plan
Decision
change
the size of the marble pieces: whole chips, halves, crushed
measure
the volume of gas in a syringe after 30 s
keep the same
the mass of marble, 50 cm³ of the same acid, the temperature, the same apparatus
repeat
3 times, find the mean, leave out an anomalous result
safety
adult or teacher only for the acid; goggles; no child handles the acid
A plan for a fair test of the effect of the size of the pieces. A teacher or an adult carries out the reaction.
Class activity
Fast, slow or the same? With an adult, on paper; no chemicals. Write 12 cards, each with one situation, for example ‘a cut apple left in a warm kitchen or in a fridge’, ‘wood shavings or a log in a fire’, ‘a fine or a coarse spice in a pan of hot water’, ‘milk left on a table or in a fridge’. Sort the cards into piles marked ‘faster’, ‘slower’ and ‘no clear change’ compared with the first named condition. For each card write one sentence with the word ‘collisions’ or ‘particles’. Then mark the cards in which the total amount made at the end would stay the same. Predict first, and compare your piles with an adult. Which cards were hardest, and why? What would you need to measure to test one of them fairly?
Practice
1
A gas syringe reads 9 cm³ at 15 s and 21 cm³ at 45 s. Calculate the average rate between 15 s and 45 s. Is the rate in the first 15 s likely to be greater or smaller than this? Explain.
(21 − 9) ÷ (45 − 15) = 12 ÷ 30 = 0.40 cm³/s. In the first 15 s the average is 9 ÷ 15 = 0.60 cm³/s, which is greater, because the reaction is fastest at the start when there are most reactant particles.
2
A piece of marble of mass 4.00 g is lifted out of acid after 10 minutes and, after drying, has a mass of 3.20 g. Calculate the average rate at which the marble was used up, in g/min. Will the rate in the next 10 minutes be the same, greater or smaller? Explain.
Mass used = 4.00 − 3.20 = 0.80 g, so 0.80 ÷ 10 = 0.080 g/min. The rate in the next 10 minutes will probably be smaller, because the acid is being used up and is more dilute, and the piece is smaller with less surface.
3
Three runs of marble in acid are shown. Which pair of runs is a fair test of the temperature? Which pair cannot be compared fairly, and why? Which run was fastest?
Run
Marble
Temperature
Time to finish (s)
1
large chips
20 °C
200
2
crushed
20 °C
90
3
crushed
40 °C
45
Runs 2 and 3 differ only in temperature, so they are a fair test of it. Runs 1 and 3 differ in two things (size of pieces and temperature), so we cannot tell which caused the difference. Run 3 was fastest: small pieces and warm.
4
Kofi chews an antacid tablet and Nodira swallows an identical one whole. Which tablet starts to work faster in the stomach, and why? Will one of them neutralise more acid in the end? Explain.
The chewed tablet starts faster: the pieces have a larger surface area, so more particles are exposed to collisions with the acid. In the end the same amount of acid is neutralised, because both tablets contain the same amount of the reactant.