AdvertisementYour brand could be hereYour brand hereOn every Darslab page · students, parents and teachersinfo@darslab.comAsk for pricesPricesinfo@darslab.com
☰ Year plan · Science

Measuring rates of reaction

Week 29 · Unit 8 · 8.1 · 3 lessons
3

Collisions and fair measuring

Workbook 9: Topic 8.1, pp. 149–155
GoalUse collision theory to explain why a reaction slows down, and judge how well a rate has been measured.
New words
collision theory · particles react only when they collide, and only if the collision has enough energysuccessful collision · a collision with enough energy to cause a reactionrepeat · doing the measurement again, so that a mean can be foundanomalous result · a result that does not fit the pattern, often caused by a mistake
Explanation

Collision theory says that particles can react only when they collide, and only when the collision has enough energy. So the rate depends on how often particles collide and on how many of the collisions are successful. At the start there are many reactant particles, so there are many collisions in each second and the rate is high. As the reactants are used up there are fewer of them, the collisions become less frequent, and the rate falls. When one reactant has gone, that reaction cannot go on, and the graph is flat. Measuring takes care too. The gas can escape before the bung is in, the timer can be started late, some carbon dioxide dissolves in water, and a balance may not show a small loss. Repeating a measurement three times and finding the mean makes the result more reliable, and an anomalous result can be left out if you say so.

startlater
Worked examples
ElementAtoms on the leftAtoms on the right
Ca1 (CaCO₃)1 (CaCl₂)
C1 (CaCO₃)1 (CO₂)
O3 (in CaCO₃)3 (1 in H₂O + 2 in CO₂)
H2 (2HCl)2 (H₂O)
Cl2 (2HCl)2 (CaCl₂)
Teacher demonstration: lumps of limestone (calcium carbonate) in dilute hydrochloric acid in a flask on a balance, with a loose cotton wool plug to stop spray. CaCO₃ + 2HCl → CaCl₂ + H₂O + CO₂. The atoms are all still there, so the equation balances. The flask loses mass only because the carbon dioxide escapes.
RunGas after 60 s (cm³)
149
252
361
Repeats. Three runs gave these volumes after 60 s. Runs 1 and 2 are close and run 3 is far from them, so run 3 is probably anomalous. The mean of runs 1 and 2 is (49 + 52) ÷ 2 = 50.5 cm³. With run 3, the mean (54) would be pulled up. If a cause cannot be found, repeat again rather than just delete a value.
ProblemEffect on the resultsBetter way
gas escapes while the bung is pushed involume too low at every timefit the bung first and tip the flask to mix, or start the timer at once
the timer is started lateall the times are too shortstart the timer at the moment of mixing
carbon dioxide dissolves a little in water over which it is collectedvolume too lowuse a gas syringe
the balance reading drifts in a draughtmass lost looks wrongshield the balance and use a lid or cotton wool plug
Sources of error and how to reduce them.
Class activity

Fizz fade. With an adult. You need a clear glass with 200 mL of cool tap water, an effervescent tablet kept just for this (not to be eaten or drunk), and a timer. The adult drops the tablet in and you keep your face back. Every 10 seconds for 60 seconds, give the fizzing a score from 0 (none) to 5 (very strong) and write it in the table. Draw a bar chart. Predict first: which 10 seconds will score highest? Then evaluate: you gave the scores by eye, so how could another person get a different answer? Suggest one change, such as filming the glass and counting, or timing how long until the fizzing stops, to make the measuring better. Wash your hands afterwards.

Practice
1
Explain, using collisions, why the rate of a reaction in a flask falls as time goes on.
2
Four runs of an experiment gave these volumes. Which is anomalous? Find the mean of the others and suggest one possible cause.
RunGas after 90 s (cm³)
131
233
332
424
3
In the limestone demonstration, the balance shows a mass 1.1 g lower at the end. Where has the mass gone, and has the law of conservation of mass been broken?
4
Choose the best way to follow each reaction: the balance, a gas syringe, or a stopwatch.
ReactionWhat happens
Aa solid fizzes in an open flask and a heavy gas escapes
Ba flask joined by a tube to a syringe makes hydrogen, which is very light
Ca clear liquid slowly turns cloudy