GoalRead a rate graph: where it is steepest, when the reaction ends, and why the final amount depends on the limiting reactant.
New words
gradient · how steep a line is: the change up divided by the change alongplateau · the flat part of a graph, where no more product is madelimiting reactant · the reactant that is used up first, which stops the reactionexcess · more of a reactant than is needed, so some is left over
Explanation
On a graph of product against time, the steepness of the line is the rate. A steep line means fast, a gentle line means slow, and a flat line means that nothing more is being made. Most rate graphs start steep, curve over and level off. They bend because the reactants are being used up and the reaction slows. They level off when one reactant has run out. That reactant is the limiting reactant, and the total amount of product depends on how much of it there was, not on how fast the reaction went. A faster reaction gets to the plateau sooner, but the same amount of limiting reactant gives the same final amount. If you double the limiting reactant, the final amount doubles. If the gas escapes from an open flask, the balance reading falls and the line slopes down, and a steeper slope downwards still means a faster reaction.
Worked examples
Time (s)
Gas from 25 cm³ acid (cm³)
Gas from 50 cm³ acid (cm³)
0
0
0
20
22
22
40
36
42
60
45
59
80
50
73
100
53
85
120
55
95
140
56
102
160
56
107
180
56
110
200
56
112
Two runs with the same concentration of acid and plenty of baking soda, but 25 cm³ of acid in one and 50 cm³ in the other. The first 20 seconds are the same: 22 cm³ and a rate of 1.10 cm³/s, because the concentration is the same. Then the smaller amount of acid runs out first and its graph flattens first. The larger amount makes twice the gas, 112 cm³ and not 56 cm³, because there is twice as much of the limiting reactant, the acid.
What if the baking soda is the limiting reactant? With 25 cm³ of the acid, the final volume rises with the mass of baking soda until the acid is the one that runs out, and then it stops rising.
A graph of the balance reading in an open flask goes down and then flattens. The 1.00 g of carbon dioxide that left in 120 s is the lost mass. The line slopes down because the flask is losing mass, and it is steepest at the start.
Class activity
A draining model. With an adult, outdoors or over a sink. You need a clear plastic cup or bottle with a strip of tape marked in centimetres up the side, a small hole near the bottom made by the adult, a jug of water and a timer. Cover the hole with a finger, fill the cup to the 10 cm mark, uncover the hole and start the timer. Write down the time when the level reaches 8 cm, 6 cm, 4 cm and 2 cm. Predict: will the level fall by the same amount in every equal time? Plot level against time. Where is the graph steepest? In the model the water stands for the reactant, and the falling speed stands for the rate, which falls as the reactant runs out. Limits: in the cup the speed falls because the pressure of the water above gets less, not because of collisions, so the model shows only the pattern.
Practice
1
The three graphs show gas from three runs of one reaction. Which run starts fastest? Which two runs used the same amount of limiting reactant? Which used the least?
P starts fastest (steepest). P and Q end at the same volume, 40 cm³, so they had the same amount of limiting reactant, but Q is slower. R used the least (20 cm³).
2
Use the table. Find the mass lost in the first minute, the average rate for that minute in g/min, and the time by which the reaction had finished.
Time (s)
0
30
60
90
120
150
Balance reading (g)
98.40
98.00
97.76
97.64
97.60
97.60
98.40 − 97.76 = 0.64 g lost in 60 s, which is a rate of 0.64 g/min. The reading stops changing from 120 s, so the reaction had finished by about 120 s.
3
Nodira says: ‘Run 2 reached its plateau sooner, so it must have made more gas.’ Explain what is wrong.
Reaching the plateau sooner shows a faster reaction, not a bigger amount. The final amount depends on how much limiting reactant there was. A run with a faster rate and less limiting reactant would level off sooner at a lower value.
4
In the lesson, 25 cm³ of acid gave 56 cm³ of gas. With the same concentration, plenty of baking soda and 75 cm³ of acid, what final volume do you expect? How will the first 20 seconds look?
Three times as much acid gives 3 × 56 = 168 cm³. The start is the same: about 22 cm³ in 20 s (1.10 cm³/s), because the concentration has not changed.