AdvertisementYour brand could be hereYour brand hereOn every Darslab page · students, parents and teachersinfo@darslab.comAsk for pricesPricesinfo@darslab.com
☰ Year plan · Science

Electromagnets

Week 34 · Unit 9 · 9.3 · 3 lessons
2

Build an electromagnet

Learner’s Book 8: Topic 9.3, pp. 305–310
GoalBuild an electromagnet, find and reverse its poles, and say why the wire must be insulated.
New words
coil · wire wound into many turnscore · the magnetic material, such as an iron nail, inside the coilcurrent · the flow of electric charge round a circuitinsulated wire · wire covered in plastic so that current cannot pass through the covering
Explanation

To make an electromagnet, wind insulated wire in a tight coil round an iron nail. The wire is the coil and the nail is the core. Join the ends of the wire to a cell and a switch to make a circuit. When the switch is closed, a current flows in the coil and the nail becomes a magnet, so it picks up steel paperclips. When the switch is opened, the nail soon stops being a magnet, apart from a trace, and the clips fall. The plastic covering matters, because bare wire touching the nail or itself would let the current take a shortcut. The clips cling to the ends of the nail because the poles are at the ends. A compass finds the poles: the north-pointing end of its needle swings towards a south pole. A bar magnet also works, since unlike poles attract and like poles repel. The poles swap if you reverse the connections to the cell or wind the coil the other way. For safety use one small cell only, switch on for a few seconds, and tell an adult if the wire gets warm.

iron nailcoil of wirecellswitchpaper clips
Worked examples
Switch closed. The current flows, the nail is magnetised and the end of the nail picks up paperclips.
Switch open. There is no current, so the nail is no longer a magnet. The clips drop on to the table.
Cell connectedCompass needle’s north endPoint of the nail is
one waymoves towards the naila south pole
other waymoves away from the naila north pole
Finding a pole. A compass is held near the point of the nail with the switch closed. The north-pointing end of the needle swings towards the nail, so the point of the nail is a south pole. After the cell is turned round, the needle is pushed away instead, so that end is now a north pole.
Class activity

Build and test, with an adult. You need about 1 m of thin plastic-coated wire (an adult strips 1 cm from each end), a large iron nail, one AA or AAA cell in a holder, a paperclip or card switch, and small steel paperclips. Wind 20 tight turns round the nail and join the ends to the cell and switch. Close the switch for a few seconds only and count the clips lifted at the point, the head and the middle of the nail, in a table. Then hold a compass near each end and note which way the needle turns. Do not leave the switch on, because the cell goes flat and the wire can get warm; if it does, disconnect at once and tell the adult. Never use a socket, a car battery or a button cell.

Practice
1
Omar winds bare copper wire round the nail with the turns touching each other. Predict what goes wrong, and say how to fix it.
WireTurns touching?
bareyes
plastic-coatedno
2
The switch of this electromagnet is open. What do you predict will happen to the clips when the switch is closed?
iron nailcoil of wirecellswitchpaper clips
3
Describe two ways to reverse the poles of an electromagnet.
4
With the switch closed, the north end of a compass needle is pulled towards the head of the nail. What kind of pole is the head?
??