GoalInvestigate how the angle of refraction changes with the angle of incidence, and use refraction to explain everyday effects.
New words
angle of refraction · the angle between the refracted ray and the normallens · a shaped piece of clear glass or plastic with curved surfaces, used to bring light together or spread it outapparent depth · how deep an object in water seems to be, which is less than its real depthinterpolate · to read a value between two measured values on a graph or table
Explanation
To investigate refraction, shine a narrow beam of light at a rectangular block at different angles of incidence and mark the beam where it enters and leaves. Join the marks, draw the normals and measure the angles. The independent variable is the angle of incidence, and the dependent variable is the angle of refraction. For every angle bigger than 0° the angle of refraction is smaller than the angle of incidence, and when the angle of incidence is 0° the ray goes straight through. The graph is a curve, not a straight line, because the angle in glass grows more slowly than the angle in air. Refraction explains why a swimming pool looks shallower than it is, why a pencil looks broken at the surface of water and why a water drop can magnify print. Lenses are clear shapes with curved surfaces. Cameras, glasses and our own eyes use them, because refraction at curved surfaces can bring light together to make a sharp picture.
Worked examples
Angle of incidence (°)
Angle of refraction (°)
0
0
10
7
20
13
30
19
40
25
50
31
60
35
70
39
Results for a glass block, rounded to the nearest degree. The angle in the glass is always smaller than the angle in the air. At 0° the angle is 0°, with no bending. The pattern of the graph is a curve that gets flatter.
ray leaves the pool floor→bends away from the normal at the surface→eye traces it back in a straight line→floor seems nearer the surface
A swimming pool looks shallower than it is. Light from the pool floor leaves the water and bends away from the normal at the surface. Your eye follows the ray back in a straight line, so the floor seems higher up. This is called apparent depth.
Lenses are used in many tools. Each uses curved surfaces to bend light in a planned way. A magnifier makes small things look bigger; a camera lens makes a sharp picture on the sensor; glasses help the eye’s own lens to focus.
Class activity
Two refraction tricks (with an adult, using cold tap water only). (1) Arrow flip: draw a thick horizontal arrow on a card and stand it about 10 cm behind an empty clear glass. Look at it through the glass, then fill the glass with water and look again. Move the card back a little. What happens to the arrow? (2) Drop lens: lay a clear plastic sheet over some small print and put one drop of water on it. Look at the print through the drop. Record what you see in a table and say where the light changes speed.
Practice
1
A ray enters a glass block at 35° from the normal. Draw the diagram in your notebook. Which way does the ray bend at each surface, and what is the angle at which it comes out?
At the first surface it bends towards the normal (about 22–23° inside the glass). At the second surface it bends away from the normal and comes out at 35°, parallel to the incoming ray.
2
The table gives results for a block of water and a block of glass. Which material bends the light more? How can you tell?
Angle of incidence (°)
Angle in water (°)
Angle in glass (°)
20
15
13
40
29
25
60
41
35
Glass bends it more. For the same angle of incidence the angle of refraction is smaller in glass (35°) than in water (41°).
3
Use the table of glass results in the worked examples to estimate the angle of refraction when the angle of incidence is 45°.
About 28° (halfway between 25° at 40° and 31° at 50°).
4
Pour a salt solution slowly down the side of a clear glass of plain water and look through the side at a striped card behind it. Wavy lines appear where the liquids meet. Explain.
Light travels at a different speed in salt solution than in plain water, so it is refracted where the liquids mix. The boundary is uneven, so the light bends in many directions and the stripes look wavy.