Week 8 · Equilibrium on a rough inclined plane: λ = θ at the point of sliding, friction along the slope with a pull up the slope, and the two limiting cases (about to move up and about to move down) · 3 lessons
2
A pull up the slope: which way the friction acts, and checking whether the friction is limiting
Applied Mathematics Sec 2 Term 1, Unit 1, Lesson 6
GoalDecide which way friction acts when a body is pulled up a slope, and check whether it is limiting.
New words
pull up the slope · a force P along the slope, upwardstendency to move · the way the body would move if there were no friction
Explanation
Friction always opposes the tendency to move. On a slope with a pull P up the slope, the weight’s part W sin θ points down the slope. Compare the two. If P < W sin θ the body tends to slide down, so friction acts up the slope and F = W sin θ − P. If P > W sin θ the body tends to move up, so friction acts down the slope and F = P − W sin θ. If P = W sin θ no friction is needed. In both cases N = W cos θ (the pull is along the slope, so it does not change N). Then check: is F ≤ μN? If yes the body is at rest in equilibrium and the friction is F (not μN). If the needed F is larger than μN, equilibrium is impossible and the body moves. If F = μN the body is on the point of sliding.
Worked examples
A block of weight 40 N is on a 30° slope with μ = 0.4. W sin θ = 20 N and N = 40 cos 30° ≈ 34.64 N, so the limit is 0.4 × 34.64 ≈ 13.86 N. A pull of 15 N up the slope: 15 < 20, friction acts up the slope with F = 20 − 15 = 5 N ≤ 13.86: at rest.
Same block, pull 25 N up the slope: 25 > 20, so friction acts down the slope with F = 25 − 20 = 5 N ≤ 13.86: still at rest. The largest pull that keeps it at rest is 20 + 13.86 ≈ 33.86 N. A pull of 40 N would need F = 20 N > 13.86: the block moves up.
Class activity
Tie a thread to an eraser on a tilted smooth board (under 50 cm, over the desk) and pull it up the slope with a kitchen spring scale held parallel to the board. Note two readings: the pull at which it stops sliding down, and the pull at which it starts to move up.
Practice
1
A 30 N block is on a 30° slope with μ = 0.3. Find the pull up the slope that is just enough to start it moving up.
W sin θ = 15 N, N = 30 cos 30° ≈ 25.98 N, Fl ≈ 7.79 N. P = 15 + 7.79 ≈ 22.79 N.
2
The same block: what is the smallest pull up the slope that keeps it from sliding down?
P = 15 − 7.79 ≈ 7.21 N.
3
A 40 N block on a 30° slope (μ = 0.4) is pulled 10 N up the slope. Which way does friction act and how big is it? Is the friction limiting?
10 < 20, so it tends to slide down: friction acts up the slope with F = 20 − 10 = 10 N. The limit is 13.86 N, so it is not limiting.
4
What if the same block is pulled with 40 N up the slope?
F needed = 40 − 20 = 20 N, more than the limit 13.86 N, so equilibrium is impossible: the block slides up the slope.
5
Why does a pull along the slope not change the normal reaction?
It has no component perpendicular to the plane, so N = W cos θ.