Reading a vernier caliper
A ruler reads whole millimetres, but a vernier caliper reads tenths of a millimetre. It has a fixed main scale in millimetres and a sliding vernier scale. Ten vernier divisions fit into only 9 mm, so one vernier division measures 0.9 mm and falls short of a main division by 0.1 mm. That difference, 1 − 0.9 = 0.1 mm, is the least count. To read it: first, read the main scale at the last mark that the vernier zero has passed. Second, find the vernier line that lines up with any line of the main scale and note its number n. Third, add n × 0.1 mm. Always write the unit, and repeat the reading several times; the average of several readings is more reliable than one, because small slips in placing the jaws change from one reading to the next.
| Vernier line number | Position when the vernier zero is at 47.3 mm |
|---|---|
| 0 | 47.3 mm |
| 1 | 48.2 mm |
| 2 | 49.1 mm |
| 3 | 50.0 mm: lines up with the main mark 50 |
| Reading | Width (mm) |
|---|---|
| 1 | 12.4 |
| 2 | 12.6 |
| 3 | 12.5 |
| average | 12.5 |
Paper vernier, with a grown-up who does the drawing with a ruler and a pencil. Draw a main strip with lines every 1 mm and a second strip with 10 lines spaced 0.9 mm apart. Slide the second strip along the first and find which line lines up for a shift of 0.3 mm, 0.5 mm and 0.8 mm. What do you notice about the number of the lined-up line? Then tie a nut to a string and time ten swings, repeating three times to practise averaging.