إعلانيمكن أن تكون علامتك التجارية هناعلامتك التجارية هنافي كل صفحة من Darslab · طلاب وأولياء أمور ومعلمونinfo@darslab.comاسأل عن الأسعارالأسعارinfo@darslab.com
☰ خطة العام · الرياضيات التطبيقية (بالإنجليزية)

Term 1 review

الأسبوع 15 · مراجعة الفصل الدراسي الأول: القوى والاتزان والاحتكاك، والمستقيمات والمستويات في الفراغ والهرم والمخروط ومعادلة الدائرة · 3 دروس
2

Review: equilibrium of three forces and of a set of forces, friction on horizontal and inclined planes

Applied Mathematics Sec 2 Term 1, Units 1–2, Review
GoalReview equilibrium of forces meeting at a point and friction on horizontal and inclined planes.
New words
equilibrium · the resultant of all forces is zero, so X = 0 and Y = 0limiting friction · the largest friction before sliding: F = μ N
Explanation

Forces in equilibrium have X = 0 and Y = 0, or three forces close a triangle (Lami: each force over the sine of the angle opposite is the same). Friction is a response: it equals the pull while the body is at rest, up to the limit F = μ N, where N is the normal reaction (not always the weight: a slanted pull changes N). On a horizontal plane, N = W for a horizontal pull; for a pull P at angle θ above the horizontal, N = W − P sin θ and the body just moves when P cos θ = μ (W − P sin θ), i.e. P = μ W / (cos θ + μ sin θ). On a plane of angle θ, along the slope W sin θ pulls the body down and N = W cos θ. The body just slides when tan θ = μ, so the angle of friction λ has tan λ = μ.

W = 40 N30°60°
Worked examples
W = 40 N30°60°
A lamp of 40 N hangs from two strings at 30° and 60° to the horizontal (the strings are perpendicular). The tensions are T₁ = 40 sin 30° = 20 N and T₂ = 40 sin 60° = 20√3 ≈ 34.64 N. Check: horizontal 20 cos 30° = 17.32 and 34.64 cos 60° = 17.32; vertical 20 × 0.5 + 34.64 × 0.866 = 10 + 30 = 40 N.
A 50 N block on a rough horizontal floor, μ = 0.4: F = 0.4 × 50 = 20 N at most. A pull of 15 N: friction 15 N, no motion. A pull of 30 N: it slides (friction 20 N). A slanted pull at 30° above the horizontal that just moves it: P = 0.4 × 50 / (cos 30° + 0.4 sin 30°) = 20 / 1.066 ≈ 18.76 N, less than 20 N because the pull lifts a little of the weight.
θWNF
A 50 N block on a plane with sin θ = 0.6 (θ ≈ 36.87°), μ = 0.5. Along the slope W sin θ = 30 N; N = W cos θ = 40 N; Fmax = 0.5 × 40 = 20 N < 30 N, so the block slides. The least force up the slope that holds it: P = 30 − 20 = 10 N. The angle of friction: tan λ = 0.5, λ ≈ 26.57°, smaller than θ, which agrees.
Class activity

Make a smooth ramp from a board and a stack of books (an adult supervises). Put a small box on it and raise the ramp slowly until the box just starts to slide. Measure the height and the base to find tan θ. That number is about μ for that box and board. Try a second surface (a cloth on the board) and compare.

Practice
1
An 80 N block on a floor with μ = 0.25 is pulled by 12 N horizontally. What is the friction? What pull just moves it?
2
A weight of 24 N hangs from two equal strings, each at 30° to the horizontal. Find the tension.
3
A body just slides down a plane when μ = 1 / √3. Find the angle of the plane.
4
A 45 N block rests on a rough plane inclined at 20°. Find the friction and its direction.
5
Find the angle of friction when μ = 0.75.